| |
| Section 1 |
| |
| Product description |
|
XADO Grease |
| Class designation/chemical |
|
Soap-based grease with mineral additives
|
| Formulation |
|
Grease with additives |
| Manufacturer's name |
|
XADO Corp. |
| Address |
|
Kharkov, Ukraine, 4 23rd Avgusta Lane
fax: 8-10-38-0572-185-499
tel: 8-10-38-0572-185-488
|
| |
Section 2
Dangerous components |
| |
| Dangerous components |
|
Minerals-containing dust |
When used normally, no mineral-containing dust is
detected in the air. |
| |
Section 3
Health hazard |
| |
| MAC of dust in the air of the working zone |
|
6mg/m3, Safety Class 4 |
| Radiation control |
|
1 Class of Classification Unrestricted use |
Continuous or repeated contact will not cause skin irritation.
Eye contact with the product can cause irritation. |
| |
Section 4
Actions in case of an accident and first aid |
| |
|
Eye contact:
- rinse with pure water until the irritation stops;
- if the irritation persists, seek medical aid.
Skin contact:
- rinse with pure soapy water.
Inhalation:
- inhalation will not cause irritation.
Ingestion:
- if swallowed, seek medical aid;
- do not suppress vomiting.
|
| |
Section 5
Ignition and explosive data |
| |
| Flash point in open crucible,
oC, at least |
|
200 |
| Extinguishing methods |
|
in case of fire all methods of fire-fighting are applicable, except water.
|
| Special fire-fighting methods |
|
- |
| Unusual flame and explosive hazard |
|
explosion-proof |
| |
Section 6
Physical and chemical properties |
| |
| Drop point, oC |
|
183 |
| Penetration at 25 oC with agitation, mm |
|
195 |
| Viscosity, Pa*s |
|
3.3 |
| Corrosive attack on metals |
|
Withstands |
| Vaporability at 120oC, % |
|
2.0 |
| Free alkali fraction of total mass in terms of NaOH, %, max |
|
none |
| Free organic acids fraction of total mass,
mg KOH per 1 g of grease, max. |
|
0.9 |
| Water content, % (by mass) |
|
none |
| Lubricating properties when tested on
4 ball machine (20+-5)oC |
|
|
|
2450 |
|
|
980 |
|
|
32.04 |
|
|
0.65 |
| |
Section 7
Reactivity data |
| |
|
When applying, never mix this grease with calcium, potassium or aluminum greases.
Contact with alkalis, acids or water must be avoided.
Sand and other abrasive substances are not tolerated amongst mechanical impurities.
|
| |
Section 8
Spillage or leakage |
| |
|
Steps to be taken in case material is released or spilled. Recover grease wash
remainder with suitable petroleum solvent or add absorbent. Keep out of sewers and
water courses. Advise authorities if product has entered or may enter sewers and water couses.
|
| |
Section 9
Information on special protection |
| |
| Respirator |
|
not required |
| Ventilation |
|
local or centralized plenum-exhaust ventilation |
| Protective gloves |
|
not required |
| Eye protection |
|
if eye contact is likely, wear Goggles |
| Other safeguards |
|
not required |
| |
Section 10
Special precautions |
| |
|
The precautions, which should be observed during transportation and storage:
- the grease should be kept in manufacturer's containers;
- never carry or storage near sources of heat, sparkes, flame and strong oxidants.
Further precautions:
- carefully cleanse (wash) the skin after contact.
|
| |
| Grounds |
| |
- Health Report No. 63, dated 20.10.1999, of Commission of
Sanitary and Hygienic Experts on home-made products
- Report No. 85, dated 20.10.1999, of Commission of Sanitary and
Hygienic Experts on normative documentation
- Radiation Certificate No. 09/3B-2000, dated 25.02.2000
- Raw and Building Materials Quality Sheet No. 93, dated 25. 02.2000
|
| |
| Technical Director |
|
signature, second name |
| Chief Product Engineer |
|
signature, second name |
